Duckworks leading edge cut-out
- Joe Parish
- Class D
- Posts: 311
- Joined: Wed Apr 21, 2010 3:42 pm
- Location: Sioux Falls SD
Duckworks leading edge cut-out
Looking for the leading edge cut-out width? I believe I know which lights I want and they are 5 inches wide (LEDS) It does not appear the duckworks kit is much wider than that? Could not find anything on there website. Thanks
Joe
N525XC reserved
Empennage done
wings done
Fuse in progress
RV-9A
N525XC reserved
Empennage done
wings done
Fuse in progress
RV-9A
Cut out width on mine is 4 7/8". The actual mount underneath that opening is much wider (snug between the ribs).
Bruce Hill
RV-9A N5771H flying over 1100 hours!
Build Log at http://www.overthehills.com/RV-9A-Project
Blog at https://flyingoverthehills.wordpress.com/
EAA Tech Counselor, A&P
RV-9A N5771H flying over 1100 hours!
Build Log at http://www.overthehills.com/RV-9A-Project
Blog at https://flyingoverthehills.wordpress.com/
EAA Tech Counselor, A&P
- Joe Parish
- Class D
- Posts: 311
- Joined: Wed Apr 21, 2010 3:42 pm
- Location: Sioux Falls SD
Thanks guys. I do not have my kit yet but was wondering how wide the opening was. I really like aeroleds 1600 light. It is 5 inches wide and they are using it in the RV-12 kits but I did not know if it will work in the duckworks opening. I believe at 4 7/8" it will work just fine. Thanks for the info much appreciated.
Joe
N525XC reserved
Empennage done
wings done
Fuse in progress
RV-9A
N525XC reserved
Empennage done
wings done
Fuse in progress
RV-9A
They'll work just fine in the DW cutout...that's exactly what I have.
Start here-
http://www.chadandbrittne.com/October%2 ... 012-09.htm
Start here-
http://www.chadandbrittne.com/October%2 ... 012-09.htm
- Joe Parish
- Class D
- Posts: 311
- Joined: Wed Apr 21, 2010 3:42 pm
- Location: Sioux Falls SD