Flaps to fuselage gap

A forum in which to discuss topics that are not specific to a particular series of aircraft (ie. how to cut alclad)
Post Reply
Harveyseven
Class G
Posts: 5
Joined: Mon Apr 07, 2008 7:21 am
Location: Shrewsbury UK

Flaps to fuselage gap

Post by Harveyseven »

Hi,

I'm trimming my flaps on my RV7 to get the gap ‘right’ between them and the fuselage. So far I’ve got about 1/16” and wondered what gap size other builders had gone for. Too big and it will look massive and too small and it will look great in the workshop but after painting and when flying and vibrations, it might scuff the side of my shiny new aircraft.
Maybe 1/8” is ideal, however, as I can trim material off but can’t add it, I thought I’d throw it out there for any comments.
No Vans type measurements like 3/32” or 7/64” please (those who’ve built the slow build kit will understand) :)

thanks
Member of a group with an RV9A. Building my own Slow build RV7 tip-up.
Fuselage complete with tail & wigs fitted. Just started the wiring.

User avatar
bruceh
Class D
Posts: 393
Joined: Sun Apr 06, 2008 11:11 pm
Location: Ramona, CA
Contact:

Re: Flaps to fuselage gap

Post by bruceh »

I can't speak for the -7, but there are references on the plans (page 9 top view) of the RV-9 for leaving a nominal 1/4" gap between aileron and wing tip, and a nominal 3/16" gap between aileron and flap. The wing root fairings need a 1/8" gap between the side skin of the fuselage and the wing skin.
Ideally, I don't think you need to trim the flap to fuselage gap, but I know on the RV-10 it requires quite a bit of trimming. I would go with 1/8" minimum.
Bruce Hill
RV-9A N5771H flying over 1100 hours!
Build Log at http://www.overthehills.com/RV-9A-Project
Blog at https://flyingoverthehills.wordpress.com/
EAA Tech Counselor, A&P

Harveyseven
Class G
Posts: 5
Joined: Mon Apr 07, 2008 7:21 am
Location: Shrewsbury UK

Re: Flaps to fuselage gap

Post by Harveyseven »

Ok, thanks Bruce.
You’re correct in what you say, for the aileron to flap and wing tip, wing root to fuselage measurements are laid down but not a specific measurement for the flap to fuselage. I’ll go with 1/8”.
Member of a group with an RV9A. Building my own Slow build RV7 tip-up.
Fuselage complete with tail & wigs fitted. Just started the wiring.

User avatar
bullojm1
Chief Rivet Banger
Posts: 1357
Joined: Sat Mar 25, 2006 6:37 pm
Location: KDMW
Contact:

Re: Flaps to fuselage gap

Post by bullojm1 »

Which is about the same thickness as a thick sharpie!
Mike Bullock
http://www.rvplane.com
RV-7 | Superior IO-360 | Whirlwind 200RV
Garmin GTN650 | GRT Dual Sport SX EFIS
Status: FLYING!

Post Reply