Duckworks landing light

Tom Walsh · Post by **Tom Walsh** » Sun Nov 07, 2004 10:33 pm

I just finished installing the Duckworks landing light in the leading edge. The pull the lense with fiberglass tape and drill method gave me a fairly poor lense to skin fit despite pulling very hard. Any suggestions? Is taking out the light bracket and coming from behind any better....
the instructions discourage this method.

svanarts · Post by **svanarts** » Sun Nov 07, 2004 11:40 pm

I just used duck

tape to pull the lense tight to the leading edge and drilled. It helps if the plexi is warm too. Mine's not perfect either but it's acceptable.

Guest · Post by **Guest** » Fri Nov 12, 2004 2:26 pm

I must have just gotten lucky.

My lens fit perfectly. Maybe I will forego installing a landing light on the right wing.

darrylDog2000 · Post by **darrylDog2000** » Fri Nov 12, 2004 2:28 pm

Oops... That last post was me. I wasn't logged in.