Can anyone offer any good tips on fitting the stiffeners to the upper forward aft skin from the aft baggage bulkhead down to the longeron for a slider? I can't seem to get any kind of fit that seems acceptable and the drawing and plans on this are pretty worthless.
Thanks
F-6111-L&R Stiffeners
F-6111-L&R Stiffeners
Sully
RV 7 N627RS (reserved)
RV 7 N627RS (reserved)
Hey Sully,
I don't have a slider, but my friend Rob does (he's on here, and may chime in...), and I remember reading about his dealings with this part for the slider. See what he had to say about it here...
http://www.n826rc.com/viewentry.asp?id=322
May help a bit.
I don't have a slider, but my friend Rob does (he's on here, and may chime in...), and I remember reading about his dealings with this part for the slider. See what he had to say about it here...
http://www.n826rc.com/viewentry.asp?id=322
May help a bit.
Sully,
Let me know if you have questions on these -- I remember this part being WAY more difficult than it should have been. I ended up with what I think it an acceptable end result, but you can be the judge of that.
Rob
Let me know if you have questions on these -- I remember this part being WAY more difficult than it should have been. I ended up with what I think it an acceptable end result, but you can be the judge of that.
Rob
Rob Johnson
RV-7 - built, had a lot of fun, sold
1945 Piper J3 Cub
Pitts Model 12 Plans on the way....
RV-7 - built, had a lot of fun, sold
1945 Piper J3 Cub
Pitts Model 12 Plans on the way....