W423 joint plate

aparchment · Post by **aparchment** » Sun Oct 01, 2006 6:19 pm

Guys:

The instructions aren't clear on whether or not you have to fabricate W423, the leading edge joint plate. I am guessing that you have to since I don't see it labeled as a part on either the packing list or in the stuff that I have left.

Antony

cjensen · Post by **cjensen** » Sun Oct 01, 2006 6:21 pm

I believe they are in the bundle of strips that came with the kit. I didn't make mine...

captain_john · Post by **captain_john** » Sun Oct 01, 2006 6:40 pm

Yah, what he said.

It is in with all the loose, sliced sheet stuff.

Tip: Thermos' strips were SHORT! They are marked as being 36" as I recall, but his measured 1/2" shy! I measured mine (the joint plate) and it was longer than his. Van sent him 2 new ones immediately!

Check them first, before you do any fitting!

CJ

aparchment · Post by **aparchment** » Sun Oct 01, 2006 6:52 pm

Thanks guys. I will check over the stuff again.

Antony

aparchment · Post by **aparchment** » Mon Oct 02, 2006 11:25 am

Found them! They weren't labeled with the part number, only the dimensions.

Thanks again guys.

A

captain_john · Post by **captain_john** » Mon Oct 02, 2006 4:23 pm

Soooo, did you measure it?

How long is yours?

CJ

cjensen · Post by **cjensen** » Mon Oct 02, 2006 4:34 pm

OOOHHH BOY!! One could take THAT the WRONG way!!

captain_john · Post by **captain_john** » Mon Oct 02, 2006 5:11 pm

That was my intention!

I like using double entendres... in case you haven't noticed!

CJ

aparchment · Post by **aparchment** » Mon Oct 02, 2006 10:02 pm

Mine is longer than 36

captain_john · Post by **captain_john** » Mon Oct 02, 2006 10:07 pm

WHOA!!!

Good answer! I wasn't expecting that!!!

CJ

RivetBangers.com

W423 joint plate

W423 joint plate

The Boys To The Rescue

got 'em

man this water is cold, deep too